IFC 4.3.1.0 (IFC4X3_ADD1) development

8.10.4.19 Pset_MechanicalPanelOutOfPlaneNegative

8.10.4.19.1 Semantic definition

Properties for Mechanical Panels Out Of Plane Negative.

8.10.4.19.2 Applicable entities

8.10.4.19.3 Properties

Name Property Type Data Type Description
YoungModulusBending IfcPropertyTableValue IfcModulusOfElasticityMeasure/IfcPositivePlaneAngleMeasure

Defining values: α; defined values: elastic modulus in bending.

YoungModulusTension IfcPropertyTableValue IfcModulusOfElasticityMeasure/IfcPositivePlaneAngleMeasure

Defining values: α; defined values: elastic modulus in tension.

YoungModulusCompression IfcPropertySingleValue IfcModulusOfElasticityMeasure

Elastic modulus in compression.

ShearModulus IfcPropertySingleValue IfcModulusOfElasticityMeasure

A measure of the shear modulus of elasticity of the material.

BendingStrength IfcPropertyTableValue IfcPressureMeasure/IfcPositivePlaneAngleMeasure

Bending strength.

Defining values: α; defined values: bending strength.

CompressiveStrength IfcPropertyTableValue IfcPressureMeasure/IfcPositivePlaneAngleMeasure

The compressive strength of the object or material.

Defining values: α; defined values: compressive strength.

TensileStrength IfcPropertyTableValue IfcPressureMeasure/IfcPositivePlaneAngleMeasure

Indicates the ability to withstand breakage apart under applied force.

ShearStrength IfcPropertyTableValue IfcPressureMeasure/IfcPositivePlaneAngleMeasure

Defining values: α; defined values: shear strength.

BearingStrength IfcPropertyTableValue IfcPressureMeasure/IfcPositivePlaneAngleMeasure

Defining values: α; defined values: bearing strength of bolt holes, i.e. intrados pressure.

RaisedCompressiveStrength IfcPropertySingleValue IfcPressureMeasure

Alternative value for compressive strength which may be used under material and code dependent conditions (e.g. if deformation is tolerable, or far from ends of the member); conditions should be stated in SELF\IfcProperty.Description.

ReferenceDepth IfcPropertySingleValue IfcPositiveLengthMeasure

Depth in bending for which the mechanical properties are valid; provided as a means to check the integrity of material assignment.

Table 8.10.4.19.A

Edit on Github


Is this page difficult to understand? Let us know!

8.10.4.19.4 Changelog

8.10.4.19.4.1 IFC4.3_DEV_9f90c1f0

  • New resource