IFC 4.3.2.20240423 (IFC4X3_ADD2) under development

EndShapeType

Semantic definition

Defines the types of end shapes that can be used for preformed tanks. The convention for reading these enumerated values is that for a vertical cylinder, the first value is the base and the second is the top; for a horizontal cylinder, the order of reading should be left to right. For a speherical tank, the value UNSET should be used.

Referenced in
Pset_TankTypeCommon
Pset_TankTypePreformed
Table A

Edit on Github


Is this page difficult to understand? Let us know!