8.10.4.18 Pset_MechanicalPanelOutOfPlane
8.10.4.18.1 Semantic definition
Properties for Mechanica lPanels Out Of Plane.
8.10.4.18.2 Applicable entities
8.10.4.18.3 Properties
| Name | Property Type | Data Type | Description | |
|---|---|---|---|---|
| YoungModulusBending | IfcPropertyTableValue | IfcModulusOfElasticityMeasure/IfcPositivePlaneAngleMeasure |
Defining values: α; defined values: elastic modulus in bending. |
|
| YoungModulusTension | IfcPropertyTableValue | IfcModulusOfElasticityMeasure/IfcPositivePlaneAngleMeasure |
Defining values: α; defined values: elastic modulus in tension. |
|
| YoungModulusCompression | IfcPropertySingleValue | IfcModulusOfElasticityMeasure |
Elastic modulus in compression. |
|
| ShearModulus | IfcPropertySingleValue | IfcModulusOfElasticityMeasure |
A measure of the shear modulus of elasticity of the material. |
|
| BendingStrength | IfcPropertyTableValue | IfcPressureMeasure/IfcPositivePlaneAngleMeasure |
Bending strength. Defining values: α; defined values: bending strength. |
|
| CompressiveStrength | IfcPropertyTableValue | IfcPressureMeasure/IfcPositivePlaneAngleMeasure |
The compressive strength of the object or material. Defining values: α; defined values: compressive strength. |
|
| TensileStrength | IfcPropertyTableValue | IfcPressureMeasure/IfcPositivePlaneAngleMeasure |
Indicates the ability to withstand breakage apart under applied force. |
|
| ShearStrength | IfcPropertyTableValue | IfcPressureMeasure/IfcPositivePlaneAngleMeasure |
Defining values: α; defined values: shear strength. |
|
| BearingStrength | IfcPropertyTableValue | IfcPressureMeasure/IfcPositivePlaneAngleMeasure |
Defining values: α; defined values: bearing strength of bolt holes, i.e. intrados pressure. |
|
| RaisedCompressiveStrength | IfcPropertySingleValue | IfcPressureMeasure |
Alternative value for compressive strength which may be used under material and code dependent conditions (e.g. if deformation is tolerable, or far from ends of the member); conditions should be stated in SELF\IfcProperty.Description. |
|
| ReferenceDepth | IfcPropertySingleValue | IfcPositiveLengthMeasure |
Depth in bending for which the mechanical properties are valid; provided as a means to check the integrity of material assignment. |