IFC 4.3.2.20240809 (IFC4X3_ADD2) under development

7.6.4.19 Pset_WasteTerminalTypeFloorTrap

7.6.4.19.1 Semantic definition

Pipe fitting, set into the floor, that retains liquid to prevent the passage of foul air.

7.6.4.19.2 Applicable entities

7.6.4.19.3 Properties

Name Property Type Data Type Description
NominalBodyLength IfcPropertySingleValue IfcPositiveLengthMeasure

Nominal or quoted length measured along the x-axis of the local coordinate system of the object.

NominalBodyWidth IfcPropertySingleValue IfcPositiveLengthMeasure

Nominal or quoted length, measured along the y-axis of the local coordinate system of the object.

NominalBodyDepth IfcPropertySingleValue IfcPositiveLengthMeasure

Nominal or quoted length measured along the z-axis of the local coordinate system of the object.

IsForSullageWater IfcPropertySingleValue IfcBoolean

Indicates if the purpose of the floor trap is to receive sullage water, or if that is amongst its purposes (= TRUE), or not (= FALSE). Note that if TRUE, it is expected that an upstand or kerb will be placed around the floor trap to prevent the ingress of surface water runoff; the provision of the upstand or kerb is not dealt with in this property set.

SpilloverLevel IfcPropertySingleValue IfcPositiveLengthMeasure

The level at which water spills out of the object.

TrapType IfcPropertyEnumeratedValue PEnum_TrapType

Identifies the predefined types of trap from which the type required may be set.

HasStrainer IfcPropertySingleValue IfcBoolean

Indicates whether the gully trap has a strainer (= TRUE) or not (= FALSE).

OutletConnectionSize IfcPropertySingleValue IfcPositiveLengthMeasure

Size of the outlet connection from the object.

InletPatternType IfcPropertyEnumeratedValue PEnum_InletPatternType

Identifies the pattern of inlet connections to a trap.

A trap may have 0,1,2,3 or 4 inlet connections and the pattern of their arrangement may vary. The enumeration makes the convention that an outlet is either vertical or is placed at the bottom (south side) of the trap (when viewed in plan). Position 1 is to the left (west), position 2 is to the top (north), position 3 is to the right (east) and position 4 is to the bottom (south).

InletConnectionSize IfcPropertySingleValue IfcPositiveLengthMeasure

Size of the inlet connection. Note that all inlet connections are assumed to be the same size.

CoverLength IfcPropertySingleValue IfcPositiveLengthMeasure

The length measured along the x-axis in the local coordinate system or the radius (in the case of a circular shape in plan) of the cover of the object.

CoverWidth IfcPropertySingleValue IfcPositiveLengthMeasure

The length measured along the y-axis in the local coordinate system of the cover of the object.

CoverMaterial IfcPropertyReferenceValue IfcMaterialDefinition

Material from which the cover or grating is constructed.

Table 7.6.4.19.A

Edit on Github


Is this page difficult to understand? Let us know!

7.6.4.19.4 Changelog

7.6.4.19.4.1 IFC4

7.6.4.19.4.2 IFC4.3_DEV_20bdb3d